RFC 4311 - IPv6 Host-to-Router Load Sharing

(Formats: TXT)

Network Working Group R. Hinden Request for Comments: 4311 Nokia Updates: 2461 D. Thaler Category: Standards Track Microsoft November 2005
IPv6 Host-to-Router Load Sharing Status of This Memo This document specifies an Internet standards track protocol for the Internet community, and requests discussion and suggestions for improvements. Please refer to the current edition of the "Internet Official Protocol Standards" (STD 1) for the standardization state and status of this protocol. Distribution of this memo is unlimited. Copyright Notice Copyright (C) The Internet Society (2005). Abstract The original IPv6 conceptual sending algorithm does not do load sharing among equivalent IPv6 routers, and suggests schemes that can be problematic in practice. This document updates the conceptual sending algorithm in RFC 2461 so that traffic to different destinations can be distributed among routers in an efficient fashion. 1. Introduction In the conceptual sending algorithm in [ND] and in the optional extension in [ROUTERSEL], a next hop is chosen when no destination cache entry exists for an off-link destination or when communication through an existing router is failing. Normally, a router is selected the first time traffic is sent to a specific destination IP address. Subsequent traffic to the same destination address continues to use the same router unless there is some reason to change to a different router (e.g., a redirect message is received, or the router is found to be unreachable). In addition, as described in [ADDRSEL], the choice of next hop may also affect the choice of source address, and hence indirectly (and to a lesser extent) may affect the router used for inbound traffic as well. Hinden & Thaler Standards Track [Page 1] RFC 4311 IPv6 Host-to-Router Load Sharing November 2005 In both the base sending algorithm and in the optional extension, sometimes a host has a choice of multiple equivalent routers for a destination. That is, all other factors are equal and a host must break a tie via some implementation-specific means. It is often desirable when there is more than one equivalent router that hosts distribute their outgoing traffic among these routers. This shares the load among multiple routers and provides better performance for the host's traffic. On the other hand, load sharing can be undesirable in situations where sufficient capacity is available through a single router and the traffic patterns could be more predictable by using a single router; in particular, this helps to diagnose connectivity problems beyond the first-hop routers. [ND] does not require any particular behavior in this respect. It specifies that an implementation may always choose the same router (e.g., the first in the list) or may cycle through the routers in a round-robin manner. Both of these suggestions are problematic. Clearly, always choosing the same router does not provide load sharing. Some problems with load sharing using naive tie-breaking techniques such as round-robin and random are discussed in [MULTIPATH]. While the destination cache provides some stability since the determination is not per packet, cache evictions or timeouts can still result in unstable or unpredictable paths over time, lowering the performance and making it harder to diagnose problems. Round-robin selection may also result in synchronization issues among hosts, where in the worst case the load is concentrated on one router at a time. In the remainder of this document, the key words "MUST", "MUST NOT", "REQUIRED", "SHALL", "SHALL NOT", "SHOULD", "SHOULD NOT", "RECOMMENDED", "MAY", and "OPTIONAL" are to be interpreted as described in [RFC2119]. 2. Load Sharing When a host chooses from multiple equivalent routers, it SHOULD support choosing using some method that distributes load for different destinations among the equivalent routers rather than always choosing the same router (e.g., the first in the list). This memo takes no stance on whether the support for load sharing should be turned on or off by default. Furthermore, a host that does attempt to distribute load among routers SHOULD use a hash-based scheme that takes (at least) the destination IP address into account, such as those described in [MULTIPATH], for choosing a router to use. Hinden & Thaler Standards Track [Page 2] RFC 4311 IPv6 Host-to-Router Load Sharing November 2005 Note that traffic for a given destination address will use the same router as long as the Destination Cache Entry for the destination address is not deleted. With a hash-based scheme, traffic for a given destination address will use the same router over time even if the Destination Cache Entry is deleted, as long as the list of equivalent routers remains the same. 3. Security Considerations As mentioned in [MULTIPATH], when next-hop selection is predictable, an application can synthesize traffic that will all hash the same, making it possible to launch a denial-of-service attack against the load-sharing algorithm, and overload a particular router. This can even be done by a remote application that can cause a host to respond to a given destination address. A special case of this is when the same (single) next-hop is always selected, such as in the algorithm allowed by [ND]. Introducing hashing can make such an attack more difficult; the more unpredictable the hash is, the harder it becomes to conduct a denial-of-service attack against any single router. However, a malicious local application can bypass the algorithm for its own traffic by using mechanisms such as raw sockets, and remote attackers can still overload the routers directly. Hence, the mechanisms discussed herein have no significant incremental impact on Internet infrastructure security. 4. Acknowledgements The authors of this document would like to thank Erik Nordmark, Brian Haberman, Steve Deering, Aron Silverton, Christian Huitema, and Pekka Savola. Hinden & Thaler Standards Track [Page 3] RFC 4311 IPv6 Host-to-Router Load Sharing November 2005 5. Normative References [ND] Narten, T., Nordmark, E., and W. Simpson, "Neighbor Discovery for IP Version 6 (IPv6)", RFC 2461, December 1998. [RFC2119] Bradner, S., "Key words for use in RFCs to Indicate Requirement Levels", BCP 14, RFC 2119, March 1997. [ADDRSEL] Draves, R., "Default Address Selection for Internet Protocol version 6 (IPv6)", RFC 3484, February 2003. [ROUTERSEL] Draves, R. and D. Thaler, "Default Router Preferences and More-Specific Routes", RFC 4191, November 2005. 6. Informative References [MULTIPATH] Thaler, D. and C. Hopps, "Multipath Issues in Unicast and Multicast Next-Hop Selection", RFC 2991, November 2000. Authors' Addresses Robert Hinden Nokia 313 Fairchild Drive Mountain View, CA 94043 Phone: +1 650 625-2004 EMail: Dave Thaler Microsoft Corporation One Microsoft Way Redmond, WA 98052 Phone: +1 425 703 8835 EMail: Hinden & Thaler Standards Track [Page 4] RFC 4311 IPv6 Host-to-Router Load Sharing November 2005 Full Copyright Statement Copyright (C) The Internet Society (2005). This document is subject to the rights, licenses and restrictions contained in BCP 78, and except as set forth therein, the authors retain all their rights. This document and the information contained herein are provided on an "AS IS" basis and THE CONTRIBUTOR, THE ORGANIZATION HE/SHE REPRESENTS OR IS SPONSORED BY (IF ANY), THE INTERNET SOCIETY AND THE INTERNET ENGINEERING TASK FORCE DISCLAIM ALL WARRANTIES, EXPRESS OR IMPLIED, INCLUDING BUT NOT LIMITED TO ANY WARRANTY THAT THE USE OF THE INFORMATION HEREIN WILL NOT INFRINGE ANY RIGHTS OR ANY IMPLIED WARRANTIES OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE. Intellectual Property The IETF takes no position regarding the validity or scope of any Intellectual Property Rights or other rights that might be claimed to pertain to the implementation or use of the technology described in this document or the extent to which any license under such rights might or might not be available; nor does it represent that it has made any independent effort to identify any such rights. Information on the procedures with respect to rights in RFC documents can be found in BCP 78 and BCP 79. Copies of IPR disclosures made to the IETF Secretariat and any assurances of licenses to be made available, or the result of an attempt made to obtain a general license or permission for the use of such proprietary rights by implementers or users of this specification can be obtained from the IETF on-line IPR repository at The IETF invites any interested party to bring to its attention any copyrights, patents or patent applications, or other proprietary rights that may cover technology that may be required to implement this standard. Please address the information to the IETF at ietf- Acknowledgement Funding for the RFC Editor function is currently provided by the Internet Society. Hinden & Thaler Standards Track [Page 5]

Display RFC

RFC Number