Packetizer Logo
Display RFC

RFC 5161 - The IMAP ENABLE Extension

(Formats: TXT)

Network Working Group A. Gulbrandsen, Ed. Request for Comments: 5161 Oryx Mail Systems GmbH Category: Standards Track A. Melnikov, Ed. Isode Limited March 2008
The IMAP ENABLE Extension Status of This Memo This document specifies an Internet standards track protocol for the Internet community, and requests discussion and suggestions for improvements. Please refer to the current edition of the "Internet Official Protocol Standards" (STD 1) for the standardization state and status of this protocol. Distribution of this memo is unlimited. Abstract Most IMAP extensions are used by the client when it wants to and the server supports it. However, a few extensions require the server to know whether a client supports that extension. The ENABLE extension allows an IMAP client to say which extensions it supports. 1. Overview Several IMAP extensions allow the server to return unsolicited responses specific to these extensions in certain circumstances. However, servers cannot send those unsolicited responses until they know that the clients support such extensions and thus won't choke on the extension response data. Up until now, extensions have typically stated that a server cannot send the unsolicited responses until after the client has used a command with the extension data (i.e., at that point the server knows the client is aware of the extension). CONDSTORE ([RFC4551]), ANNOTATE ([ANNOTATE]), and some extensions under consideration at the moment use various commands to enable server extensions. For example, CONDSTORE uses a SELECT or FETCH parameter, and ANNOTATE uses a side effect of FETCH. The ENABLE extension provides an explicit indication from the client that it supports particular extensions. This is done using a new ENABLE command. An IMAP server that supports ENABLE advertises this by including the word ENABLE in its capability list. Gulbrandsen & Melnikov Standards Track [Page 1] RFC 5161 The IMAP ENABLE Extension March 2008 Most IMAP extensions do not require the client to enable the extension in any way. 2. Conventions Used in This Document The key words "MUST", "MUST NOT", "REQUIRED", "SHALL", "SHALL NOT", "SHOULD", "SHOULD NOT", "RECOMMENDED", "MAY", and "OPTIONAL" in this document are to be interpreted as described in [RFC2119]. Formal syntax is defined by [RFC5234] and [RFC3501]. Example lines prefaced by "C:" are sent by the client and ones prefaced by "S:" by the server. The five characters [...] means that something has been elided. 3. Protocol Changes 3.1. The ENABLE Command Arguments: capability names Result: OK: Relevant capabilities enabled BAD: No arguments, or syntax error in an argument The ENABLE command takes a list of capability names, and requests the server to enable the named extensions. Once enabled using ENABLE, each extension remains active until the IMAP connection is closed. For each argument, the server does the following: - If the argument is not an extension known to the server, the server MUST ignore the argument. - If the argument is an extension known to the server, and it is not specifically permitted to be enabled using ENABLE, the server MUST ignore the argument. (Note that knowing about an extension doesn't necessarily imply supporting that extension.) - If the argument is an extension that is supported by the server and that needs to be enabled, the server MUST enable the extension for the duration of the connection. At present, this applies only to CONDSTORE ([RFC4551]). Note that once an extension is enabled, there is no way to disable it. If the ENABLE command is successful, the server MUST send an untagged ENABLED response (see Section 3.2). Gulbrandsen & Melnikov Standards Track [Page 2] RFC 5161 The IMAP ENABLE Extension March 2008 Clients SHOULD only include extensions that need to be enabled by the server. At the time of publication, CONDSTORE is the only such extension (i.e., ENABLE CONDSTORE is an additional "CONDSTORE enabling command" as defined in [RFC4551]). Future RFCs may add to this list. The ENABLE command is only valid in the authenticated state (see [RFC3501]), before any mailbox is selected. Clients MUST NOT issue ENABLE once they SELECT/EXAMINE a mailbox; however, server implementations don't have to check that no mailbox is selected or was previously selected during the duration of a connection. The ENABLE command can be issued multiple times in a session. It is additive; i.e., "ENABLE a b", followed by "ENABLE c" is the same as a single command "ENABLE a b c". When multiple ENABLE commands are issued, each corresponding ENABLED response SHOULD only contain extensions enabled by the corresponding ENABLE command. There are no limitations on pipelining ENABLE. For example, it is possible to send ENABLE and then immediately SELECT, or a LOGIN immediately followed by ENABLE. The server MUST NOT change the CAPABILITY list as a result of executing ENABLE; i.e., a CAPABILITY command issued right after an ENABLE command MUST list the same capabilities as a CAPABILITY command issued before the ENABLE command. This is demonstrated in the following example: C: t1 CAPABILITY S: * CAPABILITY IMAP4rev1 ID LITERAL+ ENABLE X-GOOD-IDEA S: t1 OK foo C: t2 ENABLE CONDSTORE X-GOOD-IDEA S: * ENABLED X-GOOD-IDEA S: t2 OK foo C: t3 CAPABILITY S: * CAPABILITY IMAP4rev1 ID LITERAL+ ENABLE X-GOOD-IDEA S: t3 OK foo again In the following example, the client enables CONDSTORE: C: a1 ENABLE CONDSTORE S: * ENABLED CONDSTORE S: a1 OK Conditional Store enabled Gulbrandsen & Melnikov Standards Track [Page 3] RFC 5161 The IMAP ENABLE Extension March 2008 3.2. The ENABLED Response Contents: capability listing The ENABLED response occurs as a result of an ENABLE command. The capability listing contains a space-separated listing of capability names that the server supports and that were successfully enabled. The ENABLED response may contain no capabilities, which means that no extensions listed by the client were successfully enabled. 3.3. Note to Designers of Extensions That May Use the ENABLE Command Designers of IMAP extensions are discouraged from creating extensions that require ENABLE unless there is no good alternative design. Specifically, extensions that cause potentially incompatible behavior changes to deployed server responses (and thus benefit from ENABLE) have a higher complexity cost than extensions that do not. 4. Formal Syntax The following syntax specification uses the Augmented Backus-Naur Form (ABNF) notation as specified in [RFC5234] including the core rules in Appendix B.1. [RFC3501] defines the non-terminals "capability" and "command-any". Except as noted otherwise, all alphabetic characters are case-insensitive. The use of upper or lower case characters to define token strings is for editorial clarity only. Implementations MUST accept these strings in a case-insensitive fashion. capability =/ "ENABLE" command-any =/ "ENABLE" 1*(SP capability) response-data =/ "*" SP enable-data CRLF enable-data = "ENABLED" *(SP capability) 5. Security Considerations It is believed that this extension doesn't add any security considerations that are not already present in the base IMAP protocol [RFC3501]. 6. IANA Considerations The IANA has added ENABLE to the IMAP4 Capabilities Registry. Gulbrandsen & Melnikov Standards Track [Page 4] RFC 5161 The IMAP ENABLE Extension March 2008 7. Acknowledgments The editors would like to thank Randy Gellens, Chris Newman, Peter Coates, Dave Cridland, Mark Crispin, Ned Freed, Dan Karp, Cyrus Daboo, Ken Murchison, and Eric Burger for comments and corrections. However, this doesn't necessarily mean that they endorse this extension, agree with all details, or are responsible for errors introduced by the editors. 8. Normative References [RFC2119] Bradner, S., "Key words for use in RFCs to Indicate Requirement Levels", BCP 14, RFC 2119, March 1997. [RFC3501] Crispin, M., "INTERNET MESSAGE ACCESS PROTOCOL - VERSION 4rev1", RFC 3501, March 2003. [RFC5234] Crocker, D., Ed., and P. Overell, "Augmented BNF for Syntax Specifications: ABNF", STD 68, RFC 5234, January 2008. [RFC4551] Melnikov, A. and S. Hole, "IMAP Extension for Conditional STORE Operation or Quick Flag Changes Resynchronization", RFC 4551, June 2006. 9. Informative References [ANNOTATE] Daboo, C. and R. Gellens, "IMAP ANNOTATE Extension", Work in Progress, August 2006. Gulbrandsen & Melnikov Standards Track [Page 5] RFC 5161 The IMAP ENABLE Extension March 2008 Editors' Addresses Arnt Gulbrandsen Oryx Mail Systems GmbH Schweppermannstr. 8 D-81671 Muenchen Germany Fax: +49 89 4502 9758 EMail: Alexey Melnikov Isode Ltd 5 Castle Business Village 36 Station Road Hampton, Middlesex TW12 2BX UK EMail: Gulbrandsen & Melnikov Standards Track [Page 6] RFC 5161 The IMAP ENABLE Extension March 2008 Full Copyright Statement Copyright (C) The IETF Trust (2008). This document is subject to the rights, licenses and restrictions contained in BCP 78, and except as set forth therein, the authors retain all their rights. This document and the information contained herein are provided on an "AS IS" basis and THE CONTRIBUTOR, THE ORGANIZATION HE/SHE REPRESENTS OR IS SPONSORED BY (IF ANY), THE INTERNET SOCIETY, THE IETF TRUST AND THE INTERNET ENGINEERING TASK FORCE DISCLAIM ALL WARRANTIES, EXPRESS OR IMPLIED, INCLUDING BUT NOT LIMITED TO ANY WARRANTY THAT THE USE OF THE INFORMATION HEREIN WILL NOT INFRINGE ANY RIGHTS OR ANY IMPLIED WARRANTIES OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE. Intellectual Property The IETF takes no position regarding the validity or scope of any Intellectual Property Rights or other rights that might be claimed to pertain to the implementation or use of the technology described in this document or the extent to which any license under such rights might or might not be available; nor does it represent that it has made any independent effort to identify any such rights. Information on the procedures with respect to rights in RFC documents can be found in BCP 78 and BCP 79. Copies of IPR disclosures made to the IETF Secretariat and any assurances of licenses to be made available, or the result of an attempt made to obtain a general license or permission for the use of such proprietary rights by implementers or users of this specification can be obtained from the IETF on-line IPR repository at The IETF invites any interested party to bring to its attention any copyrights, patents or patent applications, or other proprietary rights that may cover technology that may be required to implement this standard. Please address the information to the IETF at Gulbrandsen & Melnikov Standards Track [Page 7]